I fitted my sportline splitter front splitter today. Still not sure on it 100% but it’s made the front bumper a bit squarer which I wanted. I was going to fit my new alloys too, took one of my old wheels off and realised I’d left the spigot rings in the shop but anyway found I have a crack in one alloy which is annoying. I’ve only had these on since March and they weren’t super cheap reps! (Rivera) Had a quick search online and because they’re not leaking air, I read jb weld is the way to fix it??
Cheers! Yeh it’s the lower sportline splitter, straight fit but you have to drill a couple of holes either side of the bumper and on the bottom for the fixings. It’s quite simple to fit
Installed coilovers to the front yesterday and while at it I also replaced the outer cv boots,also fired on my Mk6R alloys as I got new ones for my R ,my Darkside rear lowering kit will be here on Wednesday and will be ordering a new timing belt kit as well...
So striped down and removed my dash 2day and cut out the hole for the new aircon also put in my new carpets and wiring for the oe Bluetooth module still got abit of wiring to do on the aircon side but it's getting there then the Touran dash can go it