Wiring adaptor for Touran seats upgrade

[arkonline]

Hello all.

I've got a 2018 Caddy Maxi that I've been working on upgrading over Christmas.

I picked up some nice Touran seats but obvs the cabling is different. The blue plug fits okay (not sure what it does!), but the yellow (Airbag) and black (seatbelt sensor wire I think) are both different.

I don't have a heating module in the Caddy so I guess that cable will have to stay unplugged?

So I need a loom or adapter to get them to work in the Caddy. I know Stan the Caddy Man makes them apparently, but I'm not on Facebook so any other advice gratefully received. I am happy to use the donor plugs from the old Caddy seats if necessary but I'm no good at soldering.

Cheers, arkonline

[whelp]

I did this in my van.

I didn't have the functionality on the old seats so all i did was stop the seat belt light coming on (close the circuit)

[arkonline]

I think I'd have to get the yellow airbag connector done to pass MOT.

Any suggestions on where to get a loom done?

[jakemcc97]

I chopped the plugs off my old seats and spliced them on to the loom for the new seats. If you do that - splice, don't solder, and bear in mind they're small wire so need good small splices.

Ideally would've preferred adapters but only found out the plugs were opposite genders after taking the old seats out!

[Scotscad]

Hi guys, stan the man has looms for sale on ebay. So search vw T6 heated windscreen wiring loom and its the one from ireland. Thatll take u onto his page and ul be able to contact him thru ebay messages to ask him about the looms u need. Hope this helps.

[arkonline]

For anyone else who might be looking for a way to contact Stan re: wiring/looms, I found him on Instagram and contacted through there – search for Stan the VW Man. He's a top bloke.

https://www.instagram.com/stanthevwcaddyman/