CADDY2K.com

I will look tomorrow.

Fir thoose living in the LHD countries, here are the partnumbers you need for the folding mirrors:

2K5857407D
2K5857408F
2K5857521C
2K5857522A
2K5857527
2K5857528

I'm ordering theese myself too, so I can fit them with the "new" doormodules I bought (they have fold in on remote coded)


Sent from my iPhone using Tapatalk

Rear bumper for maxi

Guide Profile
2K5 807 393 A left
2K5 807 394 A right

Bumper (metal bit)
2K5 807 305

Cover
2K5 807 417 C 9B9 satin black
2K5 807 417 E GRU primed

dan@biali wrote:Rear bumper for maxi

Guide Profile
2K5 807 393 A left
2K5 807 394 A right

Bumper (metal bit)
Think this is the same number as above

Cover
2K5 807 417 C 9B9 satin black
2K5 807 417 E GRU primed

bumper (metal bit) part number ? Am I missing something ?

Thought I'd listed it in an earlier post but hadn't. Will add the number tomorrow.

You might want to read Docs post on forum etiquette - quoting the whole post immediately after the post is frowned upon as it clogs up the thread.

*I've edited the post above to add the part number for the bumper.

Yes I did read it after and it s right there are a lot more like that on the forum
Still haven't found that part number looked everywhere if only I had access to etka - any advice on where to get what you have ?
Thanks

I posted the part number in the post above. I get etka from a mate who sets it up for me. Not much help I'm afraid. You can get discs on eBay.

the long one wrote: Still haven't found that part number looked everywhere if only I had access to etka - any advice on where to get what you have ?
Thanks

Would this not do?

http://www.oemepc.com/" onclick="window.open(this.href);return false;


Only had a quick look myself, not tried the VIN number search yet


Sent from my iPhone using Tapatalk

After replacing the rear lights with the new version I have noticed a difference between them and ones that are on facelift 2 (gen 4) the bottom brake also seems to be on as a tail light and also works as a brake light - not the same as the retrofit ones - does this mean that there is another or what ?

You have to code that in your CECM (Pre Facelift or BCM (Facelift 1)


Sent from my iPhone using Tapatalk

Where about is that ? Didn't think that the brake light lamp was dual filament (stop/tail)

the long one wrote:Where about is that ? Didn't think that the brake light lamp was dual filament (stop/tail)

It's not a dual filament, that's correct.

With VCDS and the OBD2 cable you can code it in address 09

It's called something like: Backup function brake light as taillight

You can set it to a certain percentage below 40 percent, otherwise the difference is to low between tail and stoplight


Sent from my iPhone using Tapatalk

I'll give that a try over the weekend thanks
Changed coding today all good

Help? Can anyone help me with a simple guide to installing 2016 rear lights to my 2013 caddy? A simple wiring diagram or video would be great if anyone can help? Cheers guys

Caddymk3 wrote:Help? Can anyone help me with a simple guide to installing 2016 rear lights to my 2013 caddy? A simple wiring diagram or video would be great if anyone can help? Cheers guys

As indicated on the previous page of this thread: http://www.caddy2k.com/forum/viewtopic.php?t=23904" onclick="window.open(this.href);return false;