CADDY2K.com

Touran door cards trimmed, every clip and screw etc replaced in door cards plus actually having it bolted in... when doing the drivers, the inside catch fell off and had to take it back off again but found some magic stars in the armrest so I let it slide.

Plus, I have a photo of my caddy with the wheels, done 100 miles earlier, so it's all a bit dirty, but I might have a chance tomorrow to give it a clean/wax.

Sent from my SM-S908B using Tapatalk

So I went to fix the broken washer hose again, and it snapped in 2 places.. so I had to get this fixed once and for all.

Had to take the wheel arch off and undo all the tape and removed all the old plasic hose which wasn't as bad as I thought, while I was there I removed the rear hose as that's blanked anyways.

Got everything cleaned up as much as I could and blanked the pump on one side. The washers have never been so good! And only toke a couple of hours.

Also gave the van a quick clean to show off the wheels.

Sent from my SM-S908B using Tapatalk

Roof sound deadening done and insulation all sorted.

Roof lining covered in dark grey suede, all other Roof parts bar the a pillar and rear seat belt plastic painted in smoke grey too.

Waiting on a touran light and microphone so I can get rid of the ugly microphone for the aftermarket stereo..

Sent from my SM-S908B using Tapatalk

Roof lining complete.

Sent from my SM-S908B using Tapatalk

A black interior makes the cab feel so much nicer! The suede roof will tie in very nicely with your door cards

Be4ny13 wrote:A black interior makes the cab feel so much nicer! The suede roof will tie in very nicely with your door cards

Thanks mate, definitely feels alot better.

Need the front seats now!

Sent from my SM-S908B using Tapatalk

Finished the rest of the interior, and it's now all smoke grey!

Waiting on the touran interior light, which I'll paint also and still searching for some front seats, ideally heated alcantara ones.

Sent from my SM-S908B using Tapatalk

Finished interior.. waiting on touran light and vw microphone atm.

Sent from my SM-S908B using Tapatalk

that's looking really OEM
I am planning on going down the route of dyeing my A pillars and bulkhead etc in Anthracite so it all looks the same as the dash
thanks for the inspo

stu_b wrote:that's looking really OEM
I am planning on going down the route of dyeing my A pillars and bulkhead etc in Anthracite so it all looks the same as the dash
thanks for the inspo

Thanks, mate. I did think about the dye, and I've tried dark grey and anthracite paint, but they were well off, so I went with the smoke grey.

Sent from my SM-S908B using Tapatalk

did u try the dye (if so what brand) ?
or just tried painting in the two colours with unsatisfactory colour matching ?

stu_b wrote:did u try the dye (if so what brand) ?
or just tried painting in the two colours with unsatisfactory colour matching ?

Haven't tried the dye. Only different shades in rattle cans, mate.

Sent from my SM-S908B using Tapatalk

ok
I have purchased some Wurth Anthracite dye and I am yet to pull the trigger and give this a crack
might have to wait till the new year when I get some time on my hands

stu_b wrote:ok
I have purchased some Wurth Anthracite dye and I am yet to pull the trigger and give this a crack
might have to wait till the new year when I get some time on my hands

Yeah, it would be good to see how that looks after it's done!

Sent from my SM-S908B using Tapatalk

Bit of a lucky eBay purchase, been after one of these boomba gear knobs since I saw one on someone else's build. Luckily, one came up for £20.00 buy it now, so I didn't hesitate! As a bonus, I've got the 6-speed gearbox to match.

I'm thinking of cutting the shifter down an inch, though.

Sent from my SM-S908B using Tapatalk