3.2 v6 DSG Supercharged conversion

[Pineapple1984]

A short video of some light shifting!!

https://youtu.be/IC8P1-xez2s?si=Xenrk1XL7Pfxww0E


Sent from my iPhone using Tapatalk

[Brutus1989]

A short video of some light shifting!!

https://youtu.be/IC8P1-xez2s?si=Xenrk1XL7Pfxww0E


Sent from my iPhone using Tapatalk

Mega stuff this!

[Damo2k]

Sent from my SM-G973F using Tapatalk

[C Chis]

Loving the DSG shifts, I’ll need to get my finger out and get mine swapped over from manual to auto!

Good progress!


Sent from my iPad using Tapatalk

[Pineapple1984]

UH OH!!!!
That’s not the fault code you want appearing on a VR6 engine. I’m sure the chains were good on this last time I had the Audi in. Suppose that was a while ago. My own fault should of done them before it went in.

Oh well back out again then


Sent from my iPhone using Tapatalk

[Pineapple1984]

And this turned up today
But that will have to wait for now!


Sent from my iPhone using Tapatalk

[Damo2k]

Ah that's a nightmare ladbut I suppose once it's done it donewhat goodies did u get in the box

Sent from my SM-G973F using Tapatalk

[Pineapple1984]

Induction kit! Try and make the most of all this noise


Sent from my iPhone using Tapatalk

[Damo2k]

That's true

Sent from my SM-G973F using Tapatalk

[Damo2k]

This wiring loom mate is that from the a3 fuse box to ecu?

Sent from my SM-G973F using Tapatalk

[Pineapple1984]

Hi @Damo, That’s basically the whole Audi loom excluding the engine wiring loom

[Damo2k]

Ah rite did u use most of that?

Sent from my SM-G973F using Tapatalk

[Pineapple1984]

Not that much to be honest I basically started with the ECU Main plug and then followed each wire to the designation, de pinned and tagged it.


Sent from my iPhone using Tapatalk

[Damo2k]

Ah rite got ittought for a sec u did complete full loom swap..could it be done without that loom?would the caddy ecu plug fit the a3 ecu and just depin and splice them?

Sent from my SM-G973F using Tapatalk

[Damo2k]

Also when in vw erwin all I am seeing is diagrams for current flowam I missing something as cannot seem to locate the pinout diagrams.

Sent from my SM-G973F using Tapatalk