CADDY2K.com

Struggling to see/find the hole through bulkhead on drivers side (RH on UK)

Trying to add the trigger wire to the combi light switch, everything else fitted, just need to extend the ridiculously short wire & stick it in the multi block (Hole No5?)

Anybody help to pinpoint what i can't see

Remove the bulkhead steel cover, 5 X 10mm bolts from memory, then you can see where things go through the actual bulkhead.

It's the panel with the useless carpet insulation thing hanging off it. Most of the bolts are by feel only and can't be seen. Centre one is down the bottom, like others to right and left ends.

Cheers, gave up in the end & seeing as i was sorting the wobbly bonnet pull handle i just pushed the wire through that grommet